Adcon A720 Betriebsanweisung Seite 40

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 64
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 39
Using terminal commands
5 for A723
6 for A440
7 for A733 GSM
8 for A731
9 for A732
slot and samples are the actual values programmed by using the SLOT
command
po is the power output of the device during the last frame sent; this value is
relative (50 mW corresponds to a value of approx. 25, while 500 mW
corresponds to a value of approx. 200) (this parameter is irrelevant for the
A733GSM/GPRS)
err_level is the error value; 0 means no error
R
EMARKS GET only.
REMOTE Yes, GET only. The A733 can issue the command both remotely and locally.
E
XAMPLE INFO
9193 INFO 255 0 18/4/1999 21:5:11 1.3 0 0 0 91 72 40 1:46 58
65 72 3 900 15 175 0
#
PORT
AVAILABLE FOR
A731 A733A732 A733GSM
DESCRIPTION A complex command acting upon the I/O ports of a device.
PARAMETERS A control byte specifying the command, the bit of the port the command is acting
on, and two 16-bit parameters, depending on the control byte; for some
commands, one or both of them may be missing. However, if they are needed for a
certain command but not given, null values are implied.
The control byte’s significance is shown in Fig. 17.
Command Code
Port Number
Fig. 17: The Control Byte Layout
The Port Number selects the port that will be affected by the command.
For the A733, only 0000 to 0011 are accepted (only four ports are
available).
The Command Code specifies the operation that will be applied to the
selected port. They are explained in the table below.
Code Description Parameters Returns
0000 RDP – Read Data Port. This
command reads the whole 16-bit
port and returns its value; the Port
Number has no significance for this
command.
None
A 16-bit integer and
the result (OK or
ERROR). Only the
lowest four significant
bits reflect valid ports
for the A733.
40
Seitenansicht 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare