Adcon A720 Betriebsanweisung PDF herunterladen (Seite 37)

addVANTAGE Pro 6.4 Administrator Guide CHAPTER 4

Node Properties

The other difference between RTU and tag properties is the addition of the

Climate setting for an RTU immediately above the Attributes button (Figure 33).

You use this setting to select the type of climate applicable to the RTU’s location.

You can also click Detect by GPS to automatically select a climate setting based

on GPS coordinates.

Figure 33. Climate Setting on RTU Properties Dialog

See “Using the Climate Manager” on page 58 for information about climates.

Tag General Properties

Review the General tab for information about the tag, such as its class and

subclass, node ID, number of alarms and events, engineering unit used, time

zone of its server, and so forth.

Updating the addVANTAGE Pro Configuration

The tab also shows you the last time the software configuration database entries

were updated, which will usually be midnight of the current day, unless it’s set to

update at another time. However, if you don’t use automatic configuration—or if

you just want to update the configuration now—click the Update config now!

button. The system retrieves the current configuration from the server and

updates the local one. If any special conditions are reached, an event could be

issued (for example, if you specified an action based on an event such as the

engineering units being changed, the event would be registered.)

Viewing Node Attributes

The General tab has an Attributes button. Click it to display the dialog shown in

Figure 34.

Figure 34. The Attributes Dialog

This dialog shows technical information about the tag’s attributes. You close the

dialog by clicking the X in the upper right corner.

Tag DACQ Properties

As Figure 35 shows, use this tab to view information about the source and

connection status of the tag.

Figure 35. DACQ Info Tab of Tag Properties Dialog

You can click the link for the Data source to view and edit the properties of the

data source. For information about editing data sources, see “Configuring the

Data Acquisition Service” on page 50.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 104 105

Keine Kommentare

Adcon A720 Betriebsanweisung Seite 37