Adcon A720 Betriebsanweisung PDF herunterladen (Seite 28)

CHAPTER 2

System Setup

Figure 8. Changing Passwords

3. Type the new password in the edit box, confirm it by typing it

again, and then click OK to dismiss the pop-up.

4. Click Update to save the changes in the gateway.

You can also change passwords in a terminal session. See

“Changing Passwords” on page 55 to do so.

Configuring the Modems

Your gateway contains a built-in modem. This modem can be used

either for dial-in access (the “dumb server” functionality) by an

application software e.g. addVANTAGE, or as dial-out for calling

GSM based RTUs e.g. the A733GSM/GPRS station. For dial-in

access, there is no need for any special configuration; however, for

dial-out access you may need to configure some or all of the

modem parameters.

As an alternative to the built-in modem, an external modem can

also be used (e.g. a GSM modem); in this case, the external

modem should be connected on the serial port of the gateway.

Note: Only a limited number of external modems are currently

supported; some modems may work even if they are not

supported. In case of doubt contact an Adcon

representative.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 145 146

Keine Kommentare

Adcon A720 Betriebsanweisung Seite 28