Adcon A720 Betriebsanweisung PDF herunterladen (Seite 31)

CHAPTER 2

Installation

Note: You can also use a terminal to check the log file via the

emu3ap utility by typing the command calljournal. Note

also that the journal is lost after a reboot.

In case you changed various modem parameters and you don’t

seem to make the unit properly dial-out anymore, use the Restore

defaults button and the factory defaults will be restored.

Entering the license number

Most gateways are delivered with a lock on the maximum number

of active RTUs that can be inserted in the network list (typically 5).

To increase the maximum number of active RTUs you need a

license number from Adcon Telemetry that you have to enter into

the gateway (Figure 10):

Figure 10. The FileLicense... menu

• Select the FileLicense... menu. In the dialog box appearing,

enter the key.

• Press the OK button.

Now your gateway is ready for operation with a larger number of

active RTUs.

Configuring your Telemetry Network

After all the basic administrative tasks are done, you need to

prepare and configure the gateway for the addVANTAGE 4 Pro

software. This requires starting the built-in configurator software

and doing one of the following:

• Import a configuration file obtained from addVANTAGE 3.x.

• Configure the Adcon RTU network manually, if for example

you don’t have a previous addVANTAGE 3.x installation.

Since this means starting from scratch, you’ll need to refer to

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 145 146

Keine Kommentare

Adcon A720 Betriebsanweisung Seite 31