Adcon A720 Betriebsanweisung PDF herunterladen (Seite 62)

CHAPTER 3

Advanced Functions

ROUTE

DESCRIPTION Sets a route for the target device.

ARAMETERS The device ID and the route description (composed of the routing

devices’ IDs). To clear a route, provide only the target device ID (in

other words, a null route).

ETURNS OK or an error message.

EMARKS The ROUTE command updates the internal descriptors for the

specified target device. Normally, after inserting a new device, it is

assumed that this device is to be called directly, that is, no routing

stations are in between. If a station has to be routed over one or

more other stations, the gateway must know the path to be used

when calling that station. The route is given as a list of devices,

always starting from the gateway and progressing to the end-

station (see example below). Note that the number of relay stations

is limited to 8, which is in practice more than sufficient. To verify

the route a specific device uses to communicate, use the INSPECT

command (see page 79).

XAMPLE route 2333 2400 2402 2500

In the example above, station 2333 is routed over a path defined

by devices 2400, 2402 and 2500. This corresponds to the following

topographic situation:

To clear a route, use the same command, but include no

parameters for the path:

route 2333

MASTER

DESCRIPTION Set/resets the master flag of a specific device.

ARAMETERS The device ID and the flag value (on/off).

ETURNS OK or an error message.

base station

2400

2402

2500

2333

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 145 146

Keine Kommentare

Adcon A720 Betriebsanweisung Seite 62