Adcon A720 Betriebsanweisung PDF herunterladen (Seite 60)

CHAPTER 3

Advanced Functions

In either case, you need to press Enter until you get a message

stating that you are in the emu3ap command line interpreter (CLI).

Note: You can reach the gateway over the serial port or over the

built-in modem. If the network is enabled, you can also

reach it over Ethernet. You can have more than one emu3ap

process running at the same time.

Although the emu3ap software and the A730SD are very similar,

there are some slight differences in that some commands were

eliminated and other features were added.

WARNING The emu3ap interface is implemented in the A840

Telemetry Gateway only to ensure backward compatibility with

older Adcon software. This interface is obsolete and is not

recommended for new designs. All new projects should be based

on the addUPI interface. The description of this interface is given

here only for completeness.

Commands Accepted by the emu3ap Emulator

As with the A730SD, the emu3ap software supports five different

classes of commands:

• Configuration (including the SET commands)

•Data

• Administrative

• Direct radio

• Modem/GPRS/GSM

Configuration Commands

This category includes commands that configure various

parameters of the emu3ap software.

INSERT

DESCRIPTION Inserts a new device in the gateway’s internal list.

ARAMETERS The device ID number

INSERT <dev>

phone number (if the device is capable of GPRS/GSM functionality)

please check the PHONE command for further parameters eg.

shared secred.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 145 146

Keine Kommentare

Adcon A720 Betriebsanweisung Seite 60