Adcon A720 Betriebsanweisung PDF herunterladen (Seite 85)

CHAPTER 3

Operations at the Application Level

and DATA bits must be OR-ed according to the required state of

the ports.

ETURNS The actual state of the port (in hex).

EMARKS This command is deprecated; it is supported only by the A730MD

devices and early A720 devices (series 1). New devices use the

more advanced PORT command.

XAMPLE rsetio 2003 0 0

DDR 02, REG 5F

PORT

DESCRIPTION Acts upon the I/O ports of a remote device.

ARAMETERS The RTU’s ID, the byte code, and parameters (for some forms of

the command). All parameters are in decimal form (pay particular

attention to the byte code because it must be translated to

decimal).

ETURNS Status result, depends on command.

EMARKS This command is currently supported only by the A720 (series 2)

and A723 (series 3) addITs and A733 addWAVE RTUs.

XAMPLE port 9473 0

Dev 9473: incoming RF 255, outgoing RF 255

Value: 255, Error level: 0

ANALOG

DESCRIPTION Acts upon the analog input ports of a remote device.

ARAMETERS The RTU’s ID, the byte code, and parameters (for some forms of

the command). All parameters are in decimal form (pay particular

attention to the byte code because it must be translated to

decimal).

ETURNS Status result, depends on command.

EMARKS This command is currently supported only by the A723 (series 3)

addITs and the A733 addWAVE RTUs.

XAMPLE analog 9473 0

Dev 9473: incoming RF 255, outgoing RF 255

Average method: 1 2 3 4 5 6 7 5 5 5 5 5 0 0 0 0

Error level: 0

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 145 146

Keine Kommentare

Adcon A720 Betriebsanweisung Seite 85